行业标准：GBT 3933.3-2002 升降台铣床检验条件 精度检验 第3部分 立式铣床.pdf

《行业标准：GBT 3933.3-2002 升降台铣床检验条件 精度检验 第3部分 立式铣床.pdf》由会员上传分享，免费在线阅读，更多相关内容在行业资料-天天文库。

1、ICS25.080.20J54中华人民共和国国家标准GB/T3933.3-2002代替GB/T3933-1983升降台铣床检验条件精度检验第3部分:立式铣床Testconditionsformillingmachineswithtableofvariableheight-Testingofaccuracy-Part3:Machineswithverticalspindle(ISO1701-3:1997，MOD)2002一09一13发布2003一04一01实施中华人民共和国发布国家质量监督检验检疫总局GB/T3933.3-2002目次90舀·

2、················。··············，·······························。···········，，········。。··················。‘⋯II范围·······································，····································································⋯⋯12规范性引用文件·······，。。。···，，，，，。。··，甲，·······，甲，···，··

3、····“··············。。‘⋯，，··.··⋯⋯13术语及轴线表示······································，·················⋯⋯，..·········.....·.......·.......⋯⋯14一般要求·，···，，················，，···········，·······‘···························································⋯⋯14.1测量单位···················

4、···············································....................············⋯⋯14.2参照标准··············································································.·········........···⋯⋯14.3检验顺序·········，·····，·······，···········································.·······

5、·...·.....·............⋯⋯14.4检验项目·...........................................................................................................I4.5检验工具··············································································，....··················⋯⋯14.6工作精度检验···········

6、··，，··················，，···一，..··..·......⋯⋯，，，⋯，甲..⋯⋯，14.7最小公差值············，···········································································..·········⋯⋯25几何精度检验··················，，，···················。，，，················⋯⋯，······一，......····....⋯⋯，，⋯25.1轴线运动·，

7、···················，·，·········，································，······················.....······⋯⋯25.2T作台········································································································⋯⋯45.3主轴·····，····。，，，·····。。·，，，·······，，··········，·····，，··

8、···。·‘1，，·，·········，······】········，，，，·76工作精度检验········································