JB-T9087-1999 油田用往复式油泵、注水泵

《JB-T9087-1999 油田用往复式油泵、注水泵》由会员上传分享，免费在线阅读，更多相关内容在行业资料-天天文库。

1、ICS23.080J71中华人民共和国机械行业标准JB/T9087-1999油田用往复式油泵、注水泵Reciprocatingpumpforcrudeoil,waterinjectionusedinoilfield1999-07-12发布2000-01-01实施国家机械工业局发布JB/T908，一1999前言本标准是对ZBJ71005-88《油田用往复式油泵、注水泵基本参数》和ZBJ71019-89(油田用往复式油泵、注水泵技术条件》的修订。本标准与ZBJ71005-88,ZBJ71019-89相比，主要技术内容修改如下:—原基本参数标准中对泵的额定排出压力

2、、额定流量和额定输人功率以及泵的柱塞直径的规定作为标准的提示的附录;—取消了原基本参数标准中的附录A;—将技术要求中“泵的额定工况性能指标”、“泵运行时的噪声”和“泵的主要易损件的更换时间”按额定排出压力分档的档次“>31.5-50”分成“>31.5-40”和“>40-50"，且部分指标有所提高;—增加了试验方法方面的内容。本标准自实施之日起代替ZBJ71005-88和ZBJ71019-890本标准的附录A、附录B和附录C都是提示的附录。本标准由全国泵标准化技术委员会提出并归口。本标准负责起草单位:合肥通用机械研究所、山东潍坊生建机械厂。本标准主要起草人:谢

3、华桂、刘树建、王录恩、刘景娥。JB/T9087-1999目次1范围···，，·····················，··········，，··········，······················，···························，·········⋯⋯12引用标准····················，·············································，··································，·⋯⋯13基本参数·········，······，··，

4、，···········，·········。·，·········，··················，····，·········，··········，，··⋯⋯14技术要求·...............................................................................························⋯⋯25试验方法···············，，·，··。。·，···，······，，，，，，。·····，··。···，·，，，·······，··。·1·····，·

5、····，，，，···.....46检验规则·································································································⋯⋯‘⋯147标志、包装和贮存········，··..........................................··········，，·····················⋯⋯15附录A(提示的附录)基本参数············································

6、·············⋯⋯，·····....⋯⋯16附录B(提示的附录)泵的试验装置简图·....................................................................18附录C(提示的附录)试验记录·····，···········，··································.·······一...............19中华人民共和国机械行业标准JB几9087一1999油田用往复式油泵、注水泵代替ZBJ71005-88Reciprocatingpumpforcr

7、udeoil,ZB171019-89waterinjectionusedinoilfield1范围本标准规定了油田用往复式油泵、注水泵的基本参数。技术要求，试验方法，检验规则，标志、包装及贮存。本标准适用于输送温度不高于80`C，运动粘度不超过850mm2/s，机械杂质含量不超过30mg/L,固体颗粒粒径不大于15N.m，含水量不大于2%的原油及输送温度不高于80`C，总矿化度不大于30000mg/L，机械杂质含量不超过30mg/L，固体颗粒粒径不大于15p.m的油田污水或清水的往复式油泵或注水泵(以下简称泵)o泵的额定排出压力范围为10-50MPa,额定流

8、量范围为2-200m'/ho本标准不适用于固井、压裂