汽车顶棚设计指南.pdf

《汽车顶棚设计指南.pdf》由会员上传分享，免费在线阅读，更多相关内容在行业资料-天天文库。

1、目次前言······················································I范围······················································11简要说明···············································12设计构想···············································22.1人机工程分析···························

2、···············32.2间隙、台阶、公差分析····································32.3制造工艺可行性分析····································52.4装配工艺可行性分析····································52.5紧固方式··············································62.6风险分析·································

3、·············62.7主要性能要求··········································73顶棚的结构及材料类型···································73.1常用材料··············································73.2加工工艺··············································74失效模式································

4、···············7附录A(资料性附录)猎豹CP2顶棚总成图····················································8附录B(资料性附录)猎豹CS6顶棚总成图·······················································9附录C(资料性附录)猎豹CS7顶棚总成图······················································10附录D(资料性附录)PAJEROC

5、K顶棚总成图··················································11参考文献··················································································12前言本标准由湖南长丰汽车内装饰有限公司设计部提出。本标准由湖南长丰汽车内装饰有限公司设计部归口。本标准起草单位：湖南长丰汽车内装饰有限公司设计部。本标准主要起草人：本标准标准化审查人：本标准审核人：本标准批准人：汽车内饰顶棚

6、设计规范范围:本标准规定了汽车内饰顶棚在开发设计过程中应遵守的一些要求和标准，规定了汽车内饰顶棚开发的一般过程、材料选择、内饰顶棚成品规范等。本标准适用于公司开发越野车及轿车内顶棚的设计6．顶棚和遮阳板的配合2.5紧固方式顶棚后部一般用3个塑料卡扣固定,前部用遮阳板的固定座固定,如果后部有顶灯的可以通过顶灯固定.如果没有可以用2-3个塑料卡扣固定,周围用乘客扶手固定.2.6风险分析附录A（资料性附录）猎豹CP2顶棚总成图CP2普通顶棚CP2天窗顶棚附录B（资料性附录）猎豹CS6顶棚总成图CS6天窗顶棚CS6标准

7、顶棚附录C（资料性附录）猎豹CS7顶棚总成图CS7标准顶棚CS7天窗顶棚附录D（资料性附录）PAJEROCK顶棚总成图PAJEROCK标准顶棚PAJEROCK天窗顶棚