DLT854-2004带电作业用绝缘斗臂车的保养维护及在使用中的试验.pdf

《DLT854-2004带电作业用绝缘斗臂车的保养维护及在使用中的试验.pdf》由会员上传分享，免费在线阅读，更多相关内容在行业资料-天天文库。

1、ICS29.020K47备案号:DL中华人民共和国电力行业标准DL/T854一2004带电作业用绝缘斗臂车的保养维护及在使用中的试验Liveworking一Care,maintenanceandin-servicetestingofaerialdeviceswithinsulatingbooms(IECTS61813:2000,MOD)2004-03-09发布2004-06-01实施中华人民共和国国家发展和改革委员会发布DL/T854一2004目次前言·············································

2、·······································································⋯⋯n1范围·················································································································⋯⋯12规范性引用文件···········”····························································

3、························.⋯⋯13术语和定义·············································································”·························⋯⋯14一般要求············································································································⋯⋯15绝缘部件的保养·········

4、·························································································⋯⋯26绝缘斗臂车的维护································································································⋯⋯27检查······································································

5、············································⋯⋯38定期测试············································································································⋯⋯49记录···········································································································

6、·······⋯⋯910维修、重新装配······················································································..·.······⋯⋯9附录A(资料性附录)用异丙醇清洗··················································”·············⋯⋯‘二‘}-10DL/T854一2004og舌本标准是根据原国家经济贸易委员会关于下达《2001年度电力行业标准制、修订计划项目的通知》(电力〔20

7、01144号文)的安排制定的。本标准修改采用国际电工委员会标准IECTS61813作为我国电力行业标准《带电作业用绝缘斗臂车的维护保养及使用中的试验》。修改之处主要有以下几点:a)根据我国绝缘斗臂车的制造工艺现状，定期电气试验所进行的工频耐压试验，由于所施加的电压值按IEC标准显得过低，而不能发现局部的绝缘缺陷，因而定期工频耐压试验值按绝缘预防性试验的电压值施加，即增加了表4。表1、表2及表3仍按IEC标准。b)由于绝缘斗臂车的使用频度较高，将定期电气试验的周期明确为6个月，而EEC标准中规定最大间隔期为12个月。本标准附录A为资料性附录。

8、本标准由中国电力企业联合会提出。本标准由全国带电作业标准化技术委员会归口。本标准负责起草单位:武汉高压研究所、重汽集团专用汽车公司。本标准主要起草人:易辉、曹开民、胡毅、张丽华、