《GBT18900-2002-单模光纤偏振模色散的试验方法》.pdf

《《GBT18900-2002-单模光纤偏振模色散的试验方法》.pdf》由会员上传分享，免费在线阅读，更多相关内容在行业资料-天天文库。

1、ICS33.180.10M33中华人民共和国国家标准GB/T18900-2002单模光纤偏振模色散的试验方法Testmethodsforpolarizationmodedispersionofsingle-modeopticalfibres(ITU-TG.650:2000,Definitionandtestmethodsfortherelevantparametersofsingle-modefibres,NEQ)2002-12-04发布2003-05-01实施中华人民共和国发布国家质量监督检验检疫总局标准分享网www.bzfxw.com免费下载GB/T189

2、00-2002目次前言··········，··················，·················...................................................................⋯I1范围·················，，··。·················，，··。···········································，········，·，········，·，·⋯I2规范性引用文件··················。·············

3、·····························································⋯⋯13定义·....................................................................................................................14缩略语····，，········，······················，···········，······················，·····················

4、··············，⋯25斯托克斯参数测定((SPE)法·········································.....···⋯⋯，..........⋯⋯，..⋯⋯36偏振态(SOP)法·，·，··········，，，········，，··········，，·······，，，·········，，········，，········，，，，······，，一‘二77干涉(IF)法·································，············。··········，··········

5、··································⋯⋯98固定分析器(FA)法·.............................................................................，·.·....⋯⋯13附录A(资料性附录)琼斯矩阵本征分析法测量PMD的原理和过程········，··········，········⋯⋯19附录B(资料性附录)从干涉图确定PMD时延的一种方法··············，···························⋯⋯21GB/T18900-2

6、002月9吕本标准与国际电信联盟建议ITU-TG.650:2000,Definitionandtestmethodsfortherelevantparametersofsingle-modefibres中2.7节“偏振模色散的试验方法”的一致性程度为非等效。本标准的附录A、附录B为资料性附录其中，附录A修改采用IEC/TS61941:1999,Polariva-modedispersionmeasurementtechniquesforsingle-modeopticalfibres的附录E,附录B修改采用一TG.650:2000,Definitionandt

7、estmethodsfortherelevantparametersofsingle-modefibres的附本标准由中华人民共和国信息产业部提出。本标准由信息产业部电信研究院归口。本标准起草单位:武汉邮电科学研究院。本标准起草人:陈永诗。标准分享网www.bzfxw.com免费下载GB/T18900-2002单模光纤偏振模色散的试验方法范围本标准规定了单模光纤偏振模色散(PMD)的基准试验方法(RTM)和替代试验方法(ATM)，规定了对试验装置、注人条件、测量程序、计算方法、结果的统一要求。本标准适用于GB/T15972.1中规定的B类未成缆和已成缆单模光纤

8、。2规范性引用文件下列文件中的条款通过