QCT654-2005-摩托车和轻便摩托车制动器台架试验方法.pdf

《QCT654-2005-摩托车和轻便摩托车制动器台架试验方法.pdf》由会员上传分享，免费在线阅读，更多相关内容在行业资料-天天文库。

1、中华人民共和国汽车行业标准QC/T654-2005代替QC/T654-2000摩托车和轻便摩托车制动器台架试验方法Testmethodsofbrakingdevicesformotorcyclesandmopeds2005-07-26发布2006-01-01实施匡百*C"At月建不0夕李}-f发布中华人民共和国国家发展和改革委员会月匕公口2005年第46号国家发展改革委批准《钢质管道单层熔结环氧粉末外涂层技术规范》等204项行业标准(标准编号、名称及实施日期见附件)，其中石油天然气行业标准87项、汽车行业标准

2、9项、黑色冶金行业标准55项、轻工行业标准43项、锅炉压力容器行业标准10项;批准《JB4732-1995<钢制压力容器分析设计标准>)1项锅炉压力容器行业标准修改单，现予公布，《钢制压力容器分析设计标准》行业标准修改单自2005年10月1日起实施。附件:9项汽车行业标准编号、名称及实施日期中华人民共和国国家发展和改革委员会-00五年七月二十六日附件:9项汽车行业标准编号、名称及实施日期序号标准编号标准名称被代替标准编号实施日期88QC/T645-2005清障车QC/T645-20002006-01-0189

3、QC/T733-2005沙漠车辆2006-01-01摩托车和轻便摩托车发动机密封90QC/T734-20052006-01-01J性能技术要求与试验方法摩托车和轻便摩托车方向把角度91QC/T735-20052006-01-01和宽度尺寸轿车发动机钢带组合油环技术条92QC/T736-20052006-01-01件93QC/T737-2005轿车发动机铸铁活塞环技术条件2006-01-01摩托车和轻便摩托车制动器台架94QC/T654-2005QC/T654-20002006-01-01试验方法摩托车和轻便摩

4、托车制动器技术95QC/T655-2005QC/T655-20002006-01-01条件96QC/T738-2005轻便摩托车用电喇叭技术条件2006-01-01OUT654-2005目次前言···············································································································⋯⋯I1范围·····································，····，

5、，·，·······，··，，···，，，··，。，。，，···，·，。，··················。二12规范性引用文件····················，·，，···，············。，，····，·····，，····························⋯⋯13术语和定义···································································································

6、⋯⋯14试验设备·······························································，，···········，，，。·，·，，·一25试验条件·····································································································⋯⋯36试验程序及方法············································

7、·················································⋯⋯4附录A(资料性附录)试验记录表·····。···。···，，·······················。·····························⋯⋯6OUT654-2005oil吕本标准是对QC/T654-2000(摩托车和轻便摩托车制动器台架试验方法》的修订。本标准与QC/T654-2001)相比主要变化如下:—关于引用标准修订为不注日期的文件引用;-2000版标准的6.1磨合检查试

8、验、6.2磨合前效能试验,6.4磨合后效能试验,6.5基准校核中，制动间隔时间在本标准表2中取消;-2000版标准的6.5基准校核中，制动初速度第一类车为20,30km/h，本标准表2修订为第一类为30km/h;，一，2000版标准的6.6热衰退试验中，制动初速度第一类车为20km/h、第二类车为最高车速的85%、第三类车为80km/h，本标准表2修订为第一类为30km/h、第二类和第三类均为50k