jjg 863-2005 v棱镜折射仪检定规程.pdf

《jjg 863-2005 v棱镜折射仪检定规程.pdf》由会员上传分享，免费在线阅读，更多相关内容在行业资料-天天文库。

1、tftf看中华人民共和国国家计量检定规程JJG863-2005V棱镜折射仪V一prismRefractometer2005一03一03发布2005一09一03实施国家质量监督检验检疫总局发布工.G863-2005V棱镜折射仪检定规程尹0.0.钾。.0.0.0.扮扮~~~钾扮、乙46JJG863-2005VerificationRegulationofb代替JJG863-19944弓夕、。。_一_一_一_一_一。~_一_一_一_一。沪V一prismRefractometer本规程经国家质量监督检验检疫总局于2005年3月3日批准，并自2005年9月3日起施行。归

2、口单位:全国光学计量技术委员会起草单位:中国计量科学研究院本规程委托全国光学计量技术委员会负责解释标准分享网www.bzfxw.com免费下载JJG863-2005本规程起草人:刘文丽(中国计量科学研究院)杨磊(中国计量科学研究院)马振亚(中国计量科学研究院)JJG863-2005目录1范围··························································································⋯⋯(1)2概述·······································

3、···················································⋯⋯(1)3计量性能要求·...................................................................................(3)3.1测微读数系统的行差·································································⋯⋯(3)3.2测微读数系统的空程·······································

4、···························⋯⋯(3)3.3校正块的90。角误差··································································⋯⋯(3)3.4V棱镜两通光端面的平行差和V形槽90。角误差······························⋯⋯(3)3.5折射率测量误差········································································⋯⋯(3)3.6折射率测量重复性·········

5、····························································⋯⋯(3)4通用技术要求··············································································⋯⋯(3)4.1外观·······················································································⋯⋯(3)4.2仪器附件························

6、·························································⋯⋯(3)4.3光学系统成像质量·····································································⋯⋯(3)4.4视差··························································。····························⋯⋯(4)4.5平行差·····················。···········

7、···················································⋯⋯(4)5计量器具控制·························································。····················⋯⋯(4)5.1检定条件·················································································⋯⋯(4)5.2检定项目·····································

8、·········⋯⋯，’’·····