gbt 11024.1-2001 标称电压1kv以上交流电力系统用并联电容器 第1部分：总则性能、试验及定额安全要求安装及运行导则(eqviec60871-1：1997)

《gbt 11024.1-2001 标称电压1kv以上交流电力系统用并联电容器 第1部分：总则性能、试验及定额安全要求安装及运行导则(eqviec60871-1：1997)》由会员上传分享，免费在线阅读，更多相关内容在行业资料-天天文库。

1、ICS31.060.70K42中华人民共和国国家标准GB/T110241一2001eqvIEC60$71一1:1997标称电压1kV以上交流电力系统用并联电容器第1部分:总则性能、试验和定额安全要求安装和运行导则Shuntcapacitorsfora.c.powersystemshavingaratedvoltageabove1kV-Part':General-Performance,testingandrating-Safetyrequirements-Guideforinstallationandoperation2001一07一12发布2001一

2、12一01实施中华人民共和国发布国家质量监督检验检疫总局GB/T11024.1-2001前言····································⋯⋯皿IEC前言N第一篇总则1范围和目的······.·.............⋯⋯l2引用标准23定义····························⋯⋯24使用条件3第二篇质，要求和试验5试验要求46试验分类47电容测量(出厂试验)58电容器损耗角正切(tan韵测量(出厂试验卜.........................................69端子间电压试验(

3、出厂试验)610端子与外壳间交流电压试验(出厂试验》···································⋯⋯7n内部放电器件试验(出厂试验卜·········..·..·.....................⋯⋯，.....⋯⋯712密封性试验(出厂试验).·········，·······..·..·..·..·..·.........................⋯⋯7﹄13热稳定性试验(型式试验)........................................................⋯⋯了14高温下

4、电容器损耗角正切(tan的测量(型式试验)815端子与外壳间交流电压试验(型式试验卜···································。··⋯816端子与外壳间雷电冲击电压试验(型式试验卜············⋯⋯”·········⋯⋯917短路放电试验(型式试验卜····················...·..⋯⋯。....................⋯⋯g第三篇绝缘水平18绝缘水平···········..·..·.......⋯⋯9第四篇负载l9n最高允许电压2Cl2最大允许电流第五篇安全要求Q1目1放电器件···

5、···，·······。··············································································⋯⋯12nn乙︸外壳连接···············。·········。，··································。··································⋯⋯120n自J环境保护·.............................................................·······

6、·····。···················⋯⋯12n迁乙其他安全要求··················································································。··。··⋯⋯12lGB/T11024.1-2001第六篇标25l2单元的标志26l3电容器组的标志········⋯⋯第七篇安装和运行导则，.土斗27概述················································································

7、·······⋯⋯1月斗28额定电压的选择························”···········。·······························⋯⋯’‘，亡1上d29运行温度···················································································⋯⋯，亡卫J3。特殊使用条件·······································································⋯⋯’二’二1

8、‘1U31过电压·······································